//www.googletagmanager.com/ns.html?id=GTM-KZGK
University Facilities

Division 11 - Equipment

11 00 00 General Information

Design

When equipment is to be provided within the scope of the project and the design/selection is included as part of the A/E agreement, the services provided will include the identification of user needs, formulation of budgets, development of design documents for the purchase and installation of the equipment. Identification of user needs and formulation of budgets shall be accomplished during the programming and design development phases of the project. The entire process shall be closely coordinated with the user group with the Project Manager involved. The result of this process must ensure compatibility with user requirements, current University standards, as well as compliance with governing codes and regulations.

Plans and specifications shall be prepared that adequately supply information necessary to purchase and install the equipment as approved by the University. Any applicable warranty or guarantee on material, installation, and/or manufacturing workmanship must be coordinated with the Project Manager. Approval of acceptable manufacturers shall be obtained from the Project Manager prior to the release of documents.

Purchasing

The University prefers that equipment be furnished and installed under the provisions of the general construction contract. When this method of procurement is not possible or practical, it may become necessary to specify and purchase this equipment through the University Purchasing Division. This method also requires complete bid documents including instructions to bidders which will detail provisions from related documents that may apply. Bid evaluations and recommendations shall be provided to the Project Manager for review and approval prior to award of a contract. Consult with the Project Manager for information on current state procurement regulations and procedures. When this method of procurement is used, the documents for the general construction contract must contain any necessary coordination requirements for this separate delivery and installation.

Installation

The installation of equipment on a project will usually fall under one or more of the following conditions:

  • Contractor Furnished – Contractor Installed
    Installation shall conform to the provisions of the Contract Documents and be coordinated by the general contractor. Specify that the installation shall be performed by competent and trained workmen in accordance with all applicable codes and governing regulations. Specify that installation shall comply with manufacturer’s instructions. Where appropriate, the installation by the manufacturer shall be specified. Documents must specify any necessary inspection by the installer that may affect installation. Specify that the installer shall not proceed until any unsatisfactory conditions are corrected. Specify that any defects caused by unsatisfactory conditions or untimely installation shall be corrected at no cost to the Owner.
  • Owner Furnished – Contractor Installed
    Same requirements as Contractor Furnished – Contractor Installed
  • Owner Furnished – Owner Installed
    Contract Documents for the general construction contract shall identify equipment, any space requirements, and any utility connections required. Specify that installation must be coordinated with the Project Manager.
  • Contractor Furnished – Owner Installed
    Same requirements as Owner Furnished – Owner Installed

Delivery

Specify that coordination of delivery shall be the responsibility of the general contractor. The contractor shall have a representative on site to receive the shipment – the Owner will not coordinate this work.

Specify that all debris and crating material shall be removed from the site and properly disposed.

Testing and Operation

Specify that any equipment requiring testing of its operation is to be accomplished and properly documented, including any safety devices. When appropriate, operation and maintenance instruction shall be provided to the Owner’s personnel. This instruction shall include demonstration of proper use, maintenance, safety features, cleaning procedures, and proper storage and handling. Provide operation and maintenance manuals as appropriate in accordance with applicable sections of this manual.

11 80 00 Collection and Disposal Equipment

Waste Handling Equipment

The University uses the Dempster Dumpmaster method of refuse disposal.

Locate refuse containers in a service area where they are accessible to the Dumpmaster truck, but also so located that they will not be objectionably visible to the general public.

Pay special attention to designing adequate structural integrity of pavement, etc. around the dumpster container to minimize wear by repeated service. Concrete pavement has performed best in the area occupied by the truck during the actual lift operation of the container.

Consult with the Project Manager for current sizes, clearance, handling requirements for the service trucks and containers.

Utility Links

Search

Text Only Options

Top of page


Text Only Options

Open the original version of this page.

Usablenet Assistive is a UsableNet product. Usablenet Assistive Main Page.